DIRECTIONS: 1) Make sure your loom's red arrow is pointing DOWN. Otherwise, it will mess up the bracelet. First, place one band across the 2 pegs like this:
2) Keep doing this until you have a long chain of bands all the way down your loom.
3) Next, we are going to be putting a "cap band" on our loom. On the bottom pin, put a band on it and stretch it so that it doubles over. (I know this sounds confusing, but just look at the pictures down below.)
5) You are going to reach into that cap band and bring it back with you hook. Then, grab the band under it and put it onto the peg above. Be careful!
6) Keep hooking the rest of your bands until you reach the top of your loom.
7) We're almost done! Now it's time to put the c-clip onto the top 2 bands.
8) Take your bracelet off of your loom, and connect the c-clip to the opposite end of the bracelet!
I know this bracelet looks super small, but it is also very stretchy, so it should fit your wrist!